Water Tight Technologies

  RUBBERALL® Family of Products
  RUBBERALL® Membrane Qualities
  Product Specifications & Safety Data Sheets
  Warranty
  Installation Manual
    General Information
    RUBBERALL® User Cautions And Warnings!
    RUBBERALL®Tools Needed
    RUBBERALL® Products Available
    Roof Surface Preparation
    Laying Out RUBBERALL® EPDM Membrane
    Pipe Penetrations
    Protrusion In The Roof
    Adhering Membrane With Solvent Based Bonding Adhesive
    Adhering Membrane With Water Based Bonding Adhesive
    Seaming Membrane Panels With Seam Tape
    Splicing And Seaming With Rubber To Rubber Adhesive
    Alternative Panel Layout And Seaming
    Perimeter Walls & Inside Corners
    Outside Corner Finish Detail
    Cover Strip
    Peel And Stick Pipe Boot
    Pipe Or Conduit Flashings Using Uncured Flashing With Tape
    Wall Termination
    T-Joints
    Field Seam Radical Bend
    Roof Edge Termination With Metal Drip Edge
    Terminating RUBBERALL® On Fascia
    RUBBERALL® Membrane To Shingle Transition
    One Piece Drain Sleeve
    Drains With Clamping Rings
    Pitch Pockets
    Protecting RUBBERALL® Membrane In High Foot Traffic Areas (Decks)
    Repair Of RUBBERALL® Membrane
    Application Review
    Frequently Asked Questions
    Glossary
    RUBBERALL® Roofing Membrane Material And Labor Limited Warranty
    Warranty Registration
  Installation Video Guide
 
see printer-friendly version

RUBBERALL® Roofing Membrane Material And Labor Limited Warranty

30 Years on .060 inch membrane (Fully Adhered Roofing Installations Only)

20 Years on .045 inch membrane (Fully Adhered Roofing Installations Only)

RUBBERALL® EPDM in a fully adhered roofing installation is warranted against premature deterioration to the point of failure due to weathering of a period of thirty (30) years for .060-inch membrane or twenty (20) years for .045-inch membrane from the date of purchase if installed using RUBBERALL® adhesives. (Other than

RUBBERALL® tested adhesives may cause pre-mature deterioration). The holder of this warranty must keep receipts showing that both the membrane and adhesives are RUBBERALL® products. This warranty is transferable to subsequent owners.

Water Tight Technologies, LLC's (WTT) liability is limited to providing replacement membrane and the labor to install replacement membrane. The value of the credit will be determined on a pro-rata basis. For .060-inch membrane: number of remaining months of the warranty divided by 360 times the value of the replacement membrane and the labor to install. For .045-inch membrane: number of remaining months of the warranty divided by 240 times the value of the replacement material and the labor to install. Replacement accessories, other materials and replacement material shipping costs are not included in this warranty.

If a claim is made the following must be submitted: a current picture of the roof installation showing membrane deterioration; a sample of material said to have deteriorated; and original receipts showing membrane and accessories are RUBBERALL®. WTT reserves the right to inspect the roof before compensation is made under this warranty. This warranty is voided if the RUBBERALL® membrane is removed from the rooftop before a WTT representative is given the opportunity to inspect the roof for improper use of non-RUBBERALL® products or exposure to any of the non-warranted conditions noted below. This warranty does not cover the workmanship of the installer of RUBBERALL® products nor does it assure the roof will not leak due to poor workmanship of the installer. This warranty applies only to RUBBERALL® membrane installed on projects that have been registered by mailing (U.S. Postal service) the RUBBERALL® registration card or by completing the registration card found on the WTT website. Failure to use an original warranty card or to completely fill in requested information will void the warranty. It is not WTT's responsibility to return a card for more complete information. Warranty claims must be made in writing and mailed to Water Tight Technologies, LLC, P.O. Box 899 Payson, AZ  85547.

WTT shall have no obligation under this warranty for membrane deterioration caused by any of the following:

  • Natural disasters, including but not limited to lightning, fire, insect infestation, earthquake, tornado, hail, hurricanes, wind and other Acts of God.
  • Intentional or negligent acts, accidents, misuse, abuse, vandalism, civil disobedience, or the like.
  • Acids, oils, asphalt, roof patch products (other than RUBBERALL® approved products), harmful chemicals, and the like.
  • Foot traffic.

The remedies stated in this warranty are the sole and exclusive remedies for failure of the RUBBERALL®; membrane. There are no warranties, either expressed or implied, including the implied warranties of fitness for a particular purpose and merchantability, which extend beyond the warranties, stated above. Water Tight Technologies, LLC shall not be liable for any direct, incidental, consequential, special or other damages, including but not limited to loss of profits or damage to the building or its contents under any theory of law. This warranty applies to RUBBERALL®; purchased after April 1, 2002. Water Tight Technologies, LLC reserves the right to modify and/or withdraw said warranty at its discretion having given advance notification to its dealers.

 
 
Home About RUBBERALL Roofing Products Water Garden Products Contact Us About BRITE-N-EZ BRITE-N-EZ Roofing Products Roof Coatings Site Map