Water Tight Technologies

  RUBBERALL® Family of Products
  RUBBERALL® Membrane Qualities
  Product Specifications & Safety Data Sheets
  Warranty
  Installation Manual
    General Information
    RUBBERALL® User Cautions And Warnings!
    RUBBERALL®Tools Needed
    RUBBERALL® Products Available
    Roof Surface Preparation
    Laying Out RUBBERALL® EPDM Membrane
    Pipe Penetrations
    Protrusion In The Roof
    Adhering Membrane With Solvent Based Bonding Adhesive
    Adhering Membrane With Water Based Bonding Adhesive
    Seaming Membrane Panels With Seam Tape
    Splicing And Seaming With Rubber To Rubber Adhesive
    Alternative Panel Layout And Seaming
    Perimeter Walls & Inside Corners
    Outside Corner Finish Detail
    Cover Strip
    Peel And Stick Pipe Boot
    Pipe Or Conduit Flashings Using Uncured Flashing With Tape
    Wall Termination
    T-Joints
    Field Seam Radical Bend
    Roof Edge Termination With Metal Drip Edge
    Terminating RUBBERALL® On Fascia
    RUBBERALL® Membrane To Shingle Transition
    One Piece Drain Sleeve
    Drains With Clamping Rings
    Pitch Pockets
    Protecting RUBBERALL® Membrane In High Foot Traffic Areas (Decks)
    Repair Of RUBBERALL® Membrane
    Application Review
    Frequently Asked Questions
    Glossary
    RUBBERALL® Roofing Membrane Material And Labor Limited Warranty
    Warranty Registration
  Installation Video Guide
 
see printer-friendly version

Pitch Pockets

When installing a metal Pitch Pocket on a reroof project, always install a wooden nailer around the protrusion. The nailer should be wider than the base flange of the Pitch Pocket, and the same thickness as the retrofit or insulation board. Remove any foam insulation wrap to a point above the Pourable Sealer line. To ensure the Pourable Sealer will adhere to the protrusions, clean and apply Rubber to Rubber Adhesive to the protrusion, extending above the Pourable Sealer line.

Adhere the membrane up to and around the protrusion. Apply a bead of Water Cut-Off Mastic to the bottom of the Pitch Pocket and secure the pocket to the nailer.

Flash-in the Pitch Pocket using Cured and Uncured membrane/flashing, adhering the material past the top of the Pitch Pocket into the inside of the Pocket. Thoroughly mix the Pourable Sealer and fill the Pitch Pocket. Allow for slope of the Pourable Sealer from the protrusion to the Pitch Pocket.

Figure 31a – New Construction

Figure 31b – Reroof

 
 
Home About RUBBERALL Roofing Products Water Garden Products Contact Us About BRITE-N-EZ BRITE-N-EZ Roofing Products Roof Coatings Site Map