Water Tight Technologies

  RUBBERALL® Family of Products
  RUBBERALL® Membrane Qualities
  Product Specifications & Safety Data Sheets
  Installation Manual
    General Information
    RUBBERALL® User Cautions And Warnings!
    RUBBERALL®Tools Needed
    RUBBERALL® Products Available
    Roof Surface Preparation
    Laying Out RUBBERALL® EPDM Membrane
    Pipe Penetrations
    Protrusion In The Roof
    Adhering Membrane With Solvent Based Bonding Adhesive
    Adhering Membrane With Water Based Bonding Adhesive
    Seaming Membrane Panels With Seam Tape
    Splicing And Seaming With Rubber To Rubber Adhesive
    Alternative Panel Layout And Seaming
    Perimeter Walls & Inside Corners
    Outside Corner Finish Detail
    Cover Strip
    Peel And Stick Pipe Boot
    Pipe Or Conduit Flashings Using Uncured Flashing With Tape
    Wall Termination
    Field Seam Radical Bend
    Roof Edge Termination With Metal Drip Edge
    Terminating RUBBERALL® On Fascia
    RUBBERALL® Membrane To Shingle Transition
    One Piece Drain Sleeve
    Drains With Clamping Rings
    Pitch Pockets
    Protecting RUBBERALL® Membrane In High Foot Traffic Areas (Decks)
    Repair Of RUBBERALL® Membrane
    Application Review
    Frequently Asked Questions
    RUBBERALL® Roofing Membrane Material And Labor Limited Warranty
    Warranty Registration
  Installation Video Guide
see printer-friendly version

Peel And Stick Pipe Boot

1. Select the proper size of Multi-Diameter Peel and Stick Pipe Boot and cut the pipe boot above the thick index ring. DO NOT CUT DIAGONALLY THRU THE INDEX RING. The pipe boot should fit snugly over the pipe.

2. Install the pipe boot over the pipe and turn the boot inside out exposing the bottom of the boot flange. Apply Seam Tape Primer Plus at least ten inches (10") in all directions from the pipe. Remove seam tape release paper from the pipe boot. Pull the pipe boot down and adhere it to the field membrane (shown in Figure 15). Roll adhesive area with a steel roller.

3. Pull the top of the pipe boot back and apply Water Cut-Off Mastic between the pipe and boot. Bring the boot back into position and remove any excess Water Cut-Off Mastic. Install a stainless steel adjustable clamp ring over the pipe boot. Apply Lap Caulk around the top of the boot.

Figure 21

Home About RUBBERALL Roofing Products Water Garden Products Contact Us About BRITE-N-EZ BRITE-N-EZ Roofing Products Roof Coatings Site Map